New in the sports heed help.
Guys Hi . I am Pavlos from Greece and i am a new owner of a reprappro mendel which i cant finish and get to my first build. Through the whole setup i did had some problems but now i am on the printing...
View ArticleRe: New in the sports heed help.
Things are sorted out from Mr Ian. But after a firmware update i cant set the hot end temp as it keeps respong "no tool selected" Any idea ? ok i have send T0 and it is ok now. DO i have to add the T0...
View ArticleFirst prints poor quality
ok guys i have printed my first prints but i am getting poor quality at the bottom ( first layers ) . i am attaching some photos . I also have a problem with the hottend as i am getting "no tool...
View ArticleRe: New in the sports heed help.
Hi Pavlos Adding T0 to your config.g may, or may not, help. It depends what tools numbers are specified! If you have updated your SD card with the SD Image supplied with the firmware (and you ALWAYS...
View ArticleRe: New in the sports heed help.
Ian first of all thanks for ur reply. Concerning the T0 command i dont have a problem when a print gets printed but i have problem when i want to extrude some filament by my own through the software....
View ArticleRe: New in the sports heed help.
When you turn the printer on, by default, no tool is selected. Send T0, and then that tool is selected. In normal operation, you cannot extrude if the temperature is under 160C; this is a safety...
View Article